- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I bought CYCLONE IIII DEV Board recently, and followed the manual carefully, but just could not get the basic examples and DEMO to work. Following are my problems:
1) after connect to Ethernet network, the TOP LCD in the board didnt show any IP address 2) trying to run BoartTestSysteme.exe, all the tabs for GPIO, SDRAM and etc are gray, nor the configure menus , all show gray, nothing is working 3) if I switch the rotary switch to "1", then power up, DZ21 error will lit up, nothing else will happen Does the board go bad? Thanks for the help! HanaLink Copied
4 Replies
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
What does the supplier say?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
--- Quote Start --- What does the supplier say? --- Quote End --- they didn't reply anything back to me. I bought this board from Bit-ec, in Europe, they didn't pickup the phone, they didn't reply me the email. When I ordered the board, their email were responded back very quick.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Maybe programm is not downloaded.
BTW, how much do you pay for this DEV board?- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
maybe your program is not working

Reply
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page