FPGA, SoC, And CPLD Boards And Kits
FPGA Evaluation and Development Kits
5703 Discussions

Can't program FPGA on Cyclone 10 GX Development Kit. What am I doing wrong?

MEmel1
Beginner
‎08-15-2019 07:59 AM
407 Views

I compiled the project in Qurtus 17.1 Pro and trying to program the FPGA with sof file via USB-BlasterII.

 

I'm running Flash Programmer. And when I'm trying to auto detect devices in the jtag chain, it sees the MAX 10M08SA device, but can't recognize the FPGA 10CX220YF780 that goes futher. So I can't program it.

0 Kudos

Link Copied

1 Reply
YuanLi_S_Intel
Employee
‎08-16-2019 06:37 AM
180 Views

Hi Mikhail,

 

Can you try to change the switches to default position on your Cyclone 10 GX Development Kit?

 

Also, can you drag the programming file into the Quartus Programmer and then program? It should be working fine.

 

Regards,

YL

0 Kudos
Copy link
Reply

Community support is provided during standard business hours (Monday to Friday 7AM - 5PM PST). Other contact methods are available here.

Intel does not verify all solutions, including but not limited to any file transfers that may appear in this community. Accordingly, Intel disclaims all express and implied warranties, including without limitation, the implied warranties of merchantability, fitness for a particular purpose, and non-infringement, as well as any warranty arising from course of performance, course of dealing, or usage in trade.

For more complete information about compiler optimizations, see our Optimization Notice.