FPGA, SoC, And CPLD Boards And Kits
FPGA Evaluation and Development Kits
Announcements
Intel Support hours are Monday-Fridays, 8am-5pm PST, except Holidays. Thanks to our community members who provide support during our down time or before we get to your questions. We appreciate you!

Need Forum Guidance? Click here
Search our FPGA Knowledge Articles here.

Configuration- Status LED

Altera_Forum
Honored Contributor II
773 Views

Hi, fellows! 

I'm trying to program a Stratix II and I've been having some trouble with the development kit. 

In Quartus II, I assigned the pins according to the Nios Development Board Stratix II Edition Reference Manual , but after I program the device, the red led turns on and after a few seconds, the "demo" program starts running and the factory amber led is on. 

The FPGA on the board is EP2S60F672C3N but I assigned in the software, the device EP2S60F672C3 

 

Is there a problem? I don't think so because Quartus did not complain when I compiled and also when I downloaded the project into the FPGA, in fact, it even showed a message that the device was sucessfully programmed. 

 

The problem, as I mentioned before, is with the error led and pin assignments. 

 

Thanks!
0 Kudos
0 Replies
Reply