04-17-2012 04:36 PM
I use a Cyclone III starter board, I uploaded on the flash a .pof file, everything was ok.Today something strange happens: the board stops to run. I turn it off then I turn it on: the FLASH_CEN led remains on and FPGA isn't able to load the configuration. If I upload the .pof file, with Quartus, again then I press the reconfigure button it works, but at the next power on the problem returns. Does anyone have any idea? Thank you.
04-18-2012 08:02 AM
No, it isn't the DE0 board, it's the Cyclone III Starter Kit (http://www.altera.com/products/devkits/altera/kit-cyc3-starter.html).However, the problem is that everything worked, then, since yesterday, if I reboot the board it doesn't load any configuration. In your opinion the hardware is in some way damaged or there may be any other problems?