- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi all,
i have been run an example " Triple-rate SDI II Reference Design for Stratix V, Arria V & Cyclone V devices", using Cyclone V GT Development kit. , link reference on alterawiki (http://alterawiki.com/wiki/triple-rate_sdi_ii_reference_design_for_stratix_v,_arria_v_%26_cyclone_v_devices). i want to use loopback channel to display on monitor. but have an problem if i connected from output CH1 DUT ( SDI out1 on SDI HSMC Card) to input loopback channel ( SDI IN2 on SDI HSMC Card), output in loopback channel ( SDI OUT2 on SDI HSMC Card) connected to montitor. Video pattern generator have configed HD-SDI 1920x1080p@30fps, monitor have displayed an pattern.-> but i connected output from hd-sdi camera 1920x1080p@30fps to input loopback channel ( SDI IN2 on SDI HSMC Card), output in loopback channel ( SDI OUT2 on SDI HSMC Card) connected to montitor. monitor indicate to have no signal. i don't know why? who have used this kit? please please explain to me! thanks allLink Copied
0 Replies


Reply
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page