- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi there,
I just started learning fpga and accidentally found a Cyclone V GX Dev kit laying around. But I couldn’t find the pin layout of the dev board as it was discontinued a while ago.
The user manual suggested installing its dev kit installer, which I also couldn’t find. Does anyone happen to have either the pin layout or the dev kit installer for Cyclone V GX dev kit?
Many thanks
I just started learning fpga and accidentally found a Cyclone V GX Dev kit laying around. But I couldn’t find the pin layout of the dev board as it was discontinued a while ago.
The user manual suggested installing its dev kit installer, which I also couldn’t find. Does anyone happen to have either the pin layout or the dev kit installer for Cyclone V GX dev kit?
Many thanks
1 Solution
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello,
For more information regarding Cyclone V GX Dev Kit including the user manual it can be obtain through the link below.
Hope that answers your question.
Best regards,
Nazrul Naim
Link Copied
3 Replies
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
Thank you for reaching out. Allow me some time to look into your issue. I shall come back to you with findings.
Thank you for your patience.
Best Regards,
Nazrul Naim
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello,
For more information regarding Cyclone V GX Dev Kit including the user manual it can be obtain through the link below.
Hope that answers your question.
Best regards,
Nazrul Naim
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
As we do not receive any response from you on the previous question/reply/answer that we have provided, for now I will set this case to Close-Pending.
Regards,
Nazrul Naim
Reply
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page