- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello, by the Cyclone V Transceiver Native PHY IP Core is the Transceiver Reconfiguration Controller optional ? can i left the Reconfiguration output signals Open and the inputs putted to zero.
PS . I don't need to dynamically change reference clocks, PLL connectivity, and the channel configurations at runtime.
Link Copied
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
Even if there are no reconfigurations at runtime, this still needs to connect the Transceiver Reconfiguration controller to the Native PHY. You can't just leave it open without connecting or put to zero.
Regards -SK
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Thanks for the quick response SK Lim,
is it enough if I connect the transceiver with the reconfiguration controller and control only the mgmt_clk_clk and mgmt_rst_reset ? or i have to do also something with the communication interface read/write ?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Yes, you just need to hook up the signals accordingly, and control only the clk and reset signals will do.
Regards -SK Lim
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page