Cyclone3 Board Test System message: Please Configure FPGA with BTS design

FPGA, SoC, And CPLD Boards And Kits

FPGA Evaluation and Development Kits

Cyclone3 Board Test System message: Please Configure FPGA with BTS design

888 Views

I have the Cyclone3 dev board with an EP3c120.

The documentation for the Board Test System says to put switch sw5 into position 1. When I do this and power on the board, the red error LED is lit.

When I open the GUI for the Board Test System, it gives a message box with the message "Please Configure FPGA with BTS design" and an OK button. Clicking the Ok button removes he messagebox, however the Configure menu item only has EXIT as a valid option.

Help please.....

Link Copied

0 Replies

Community support is provided during standard business hours (Monday to Friday 7AM - 5PM PST). Other contact methods are available here.

Intel does not verify all solutions, including but not limited to any file transfers that may appear in this community. Accordingly, Intel disclaims all express and implied warranties, including without limitation, the implied warranties of merchantability, fitness for a particular purpose, and non-infringement, as well as any warranty arising from course of performance, course of dealing, or usage in trade.

For more complete information about compiler optimizations, see our Optimization Notice.