FPGA, SoC, And CPLD Boards And Kits
FPGA Evaluation and Development Kits
Announcements
Intel Support hours are Monday-Fridays, 8am-5pm PST, except Holidays. Thanks to our community members who provide support during our down time or before we get to your questions. We appreciate you!

Need Forum Guidance? Click here
Search our FPGA Knowledge Articles here.
5203 Discussions

Cyclone3 Board Test System message: Please Configure FPGA with BTS design

Altera_Forum
Honored Contributor II
801 Views

I have the Cyclone3 dev board with an EP3c120. 

 

The documentation for the Board Test System says to put switch sw5 into position 1. When I do this and power on the board, the red error LED is lit. 

 

When I open the GUI for the Board Test System, it gives a message box with the message "Please Configure FPGA with BTS design" and an OK button. Clicking the Ok button removes he messagebox, however the Configure menu item only has EXIT as a valid option. 

 

Help please.....
0 Kudos
0 Replies
Reply