FPGA, SoC, And CPLD Boards And Kits
FPGA Evaluation and Development Kits

DDR4 控制器摆放疑问

DXu2
Partner
446 Views

1 如何知道Arria10器件Banks 是否连续?

是根据手册里面的这个图去看?

a9555a9bd39a76ad4c766212684e1a9.png

2 在bank 里面摆放DDR, 剩余的IO是否可以当用户GPIO使用?

假如说一个bank里面DDR 占用了一个Lane ,剩下的Lane,用户可以使用?

0 Kudos
1 Reply
NurAida_A_Intel
Employee
330 Views

Dear DXu2,

 

Thank you for joining this Intel Community.

 

Please allow me to address your question as below:

 

1 如何知道Arria10器件Banks 是否连续?

是根据手册里面的这个图去看?

 

[Aida]: Yes, you are right. It is based on the picture shown in the manual. Extra info for I/O column 2 as below:

  • Bank 2L and 2H is a 3V I/O bank which does not support OCT calibration hence it is not useable for EMIF
  •  Bank 2A is not adjacent to Bank 2G and 2H. Thus, if you require multiple EMIF's which may also required multiple I/O Banks, it cannot be place in Bank 2A.

 

 

2 在bank 里面摆放DDR, 剩余的IO是否可以当用户GPIO使用?

假如说一个bank里面DDR 占用了一个Lane ,剩下的Lane,用户可以使用?

 

[Aida]: Yes, you are correct. Any pins in a bank which are not used by the external memory interface remain available for use as general purpose I/O pins only of the same voltage standard. 

 

Hope this helps. 😊

 

Thanks

 

Regards,

Aida

 

 

 

0 Kudos
Reply