DE0-Nano, Configuration via Passive Serial

[Altera_Forum]

Good day,  

I've already bought a bit DE1 and fully satisfied with it. Now I wanted to order DE0-Nano for my project.  It is configured using "Passive Serial" means PIC32.  In the circuit diagram of DE0-Nano I think unfortunately  no information where the "DATA0" lead "CONF_DONE", "DCLK",  "nSTATUS" and "nCONFIG". Is it possible to configure DE0-Nano via PS?   Dmitriy   p.S. sorry for my english...

[Altera_Forum]

Hi Dmitriy. 

 I don't one one, but since it has a EP3C16, it looks like it's probably setup as a Active Serial configuration.   The Clock, Data0, nSTATUS and nCONFIG should be all available, either at the EP3C16 or through pull-ups, but the mode select pins, may be hard wired on the board.  The only way to find out is to get a schematic, but I couldn't find one the Terasic site.  Pete

[Altera_Forum]

Hi,  

I have the schematic. It is at DE0 Nano-CDROM.  There is no configuration PROM and USB-Blaster in the schematic.  I can not understand if "DE0 nano" can be configured via AS. The configuration pins are on page 8 (bottom right), more is not there. I need the information of where these pins are connected.   Dmitriy