FPGA, SoC, And CPLD Boards And Kits
FPGA Evaluation and Development Kits
6125 Discussions

DE4 Control Panel displays "Unsupported FPGA!"

Altera_Forum
Honored Contributor II
‎11-14-2011 03:51 PM
1,272 Views

Hello, 

 

I am using the DE4 board with Quartus II 11.0 Subscription edition. When I bring up the DE4_ControlPanel.exe on my windows computer, I get the prompt "Unsupported FPGA!". I have also attached a screenshot. 

 

I was able to write logic, compile it and program the DE4 board from Quartus II; so I know the board is not fried. 

 

Has anybody else seen this? Any ideas or pointers would be appreciated. :) 

 

Thanks in advance!
Preview file
72 KB
0 Kudos

Link Copied

1 Reply
Altera_Forum
Honored Contributor II
‎11-18-2011 03:50 PM
523 Views

For those who encounter the same problem, the solution is to pre-program the FPGA using the DE4_ControlPanel_[2|5]30.sof to the board. After this is done, the control panel should be able to connect to the board.

0 Kudos
Copy link
Reply

Community support is provided Monday to Friday. Other contact methods are available here.

Intel does not verify all solutions, including but not limited to any file transfers that may appear in this community. Accordingly, Intel disclaims all express and implied warranties, including without limitation, the implied warranties of merchantability, fitness for a particular purpose, and non-infringement, as well as any warranty arising from course of performance, course of dealing, or usage in trade.

For more complete information about compiler optimizations, see our Optimization Notice.