Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Highlighted
Novice
172 Views

Does 120 ohm pull up with LED indication work for CONF_DONE for 5AGXMB1 FPGA?

As per datasheet, 10K is recommended to pull up for CONF_DONE. Attached the circuit followed in our product.

0 Kudos
7 Replies
Highlighted
25 Views

Hi SKacc,

 

Thank you for contacting Intel community.

 

Intel recommended 10k to pull up for CONF_DONE. 120 ohm can be use, but Intel will not be responsible if it is not working for the device. Hence it is better to follow Intel's guidelines.

 

Thank you.

 

Regards,

Aim

 

0 Kudos
Highlighted
Novice
25 Views

Hi Aim

 

Is there any other method for FPGA configuration status visual indication?

 

Regards

Srikanth Kacchu

0 Kudos
Highlighted
25 Views

Hi Srikanth Kacchu,

 

Usually we used LED to see the status. The LED will turn green after the conf is done. Below is the example by using Cyclone 10:

 

 

 

Regards,

Aim

0 Kudos
Highlighted
25 Views

Hi,

 

I am having an error to insert image in here, hence please look in your private message in forum for the image.

 

Regards,

Aim

0 Kudos
Highlighted
Novice
25 Views

Hi Aim

 

I couldn't find the image in My Messages. Can you able to send any link?

 

Regards

Srikanth Kacchu

0 Kudos
Highlighted
25 Views

Hi,

 

I have sent the message again. Please check.

 

Regards,

Aim

0 Kudos
Highlighted
Novice
25 Views

Hi Aim

 

Where can I see your message? If possible, please share the information to my mail kacchu.srikanth@hcl.com.

 

Regards

Srikanth Kacchu

0 Kudos