- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
We bought this board and it comes in with not able to identify FPGA onboard from Quartus. We can see USB device from a computer which we connect to. And if we disable FPGA JTAG, we can see a virtual JTAG. But we got "no valid device detected" once we enable the FPGA on board. it seems its JTAG does not work.
We would appreciate for any suggestions on how to get this board being alive.
Link Copied
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
"We sincerely apologize for the inconvenience caused by the delay in addressing your Forum queries. Due to an unexpected back-end issue in our system, your Forum cases, along with others, did not get through as intended. As a result, we have a backlog of cases that we are currently working through one by one.
Please be assured that we are doing everything we can to resolve this issue as quickly as possible. However, this process will take some time, and we kindly ask for your patience and understanding during this period. The cases will be attended by AE shortly.
We appreciate your patience and understanding, and we are committed to providing you with the best support possible.
Thank you for your understanding."
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello,
You need to configure the smartVID setting first before you can connect to the board via JTAG. Please refer to this link to connect your board via JTAG: https://www.intel.com/content/www/us/en/docs/programmable/683288/current/the-required-smartvid-qsf-assignments.html
regards,
Farabi

- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page