Community
cancel
Showing results for 
Search instead for 
Did you mean: 
ARaj
Beginner
1,007 Views

Error (209025): Can't recognize silicon ID for device 1

I am updating FPGA version for COM05 Module

Below steps I followed

Step1:I downloaded Altera Quartus version 12.1_177_programmer_ for windows in intel website.

Step2:Connected USB blaster from laptop to COM05 Module and IED powered up

Step3:Opened Altera Quartus version 12.1_177_programmer and kept below settings

USB-Blaster is set in the Hardware Setup window

Changed mode from JTAG to Active Serial Programming.

Step4:I selected the required pof file(1KHL508614 600COM05 A503) for update

Step5:Observed error message in output window

Error (209025): Can't recognize silicon ID for device 1

0 Kudos
1 Reply
Vicky1
Employee
166 Views

Hi,

Check the connection of Intel FPGA Download Cable to header available on the board.

Refer the below link,

https://www.intel.com/content/www/us/en/programmable/support/support-resources/knowledge-base/soluti...

 

Let me know if this has helped resolve the issue you are facing or if you need any further assistance.

 

Best Regards

Vikas Jathar 

(This message was posted on behalf of Intel Corporation)

 

 

Reply