- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I am updating FPGA version for COM05 Module
Below steps I followed
Step1:I downloaded Altera Quartus version 12.1_177_programmer_ for windows in intel website.
Step2:Connected USB blaster from laptop to COM05 Module and IED powered up
Step3:Opened Altera Quartus version 12.1_177_programmer and kept below settings
USB-Blaster is set in the Hardware Setup window
Changed mode from JTAG to Active Serial Programming.
Step4:I selected the required pof file(1KHL508614 600COM05 A503) for update
Step5:Observed error message in output window
Error (209025): Can't recognize silicon ID for device 1
Link Copied
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
Check the connection of Intel FPGA Download Cable to header available on the board.
Refer the below link,
Let me know if this has helped resolve the issue you are facing or if you need any further assistance.
Best Regards
Vikas Jathar
(This message was posted on behalf of Intel Corporation)
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page