FPGA, SoC, And CPLD Boards And Kits
FPGA Evaluation and Development Kits
Announcements
All support for Intel NUC 7 - 13 systems has transitioned to ASUS. Read latest update.
5853 Discussions

Ethernet MAC/PHY (LAN91C111) with Stratix II

Altera_Forum
Honored Contributor II
1,068 Views

Hello everybody, 

 

I’m a French student in electronics engineering. 

I’m trying to use the Ethernet MAC/PHY (LAN91C111 device) IP with Nios II but I have some problems with the pins assignments in Quartus II software (v9.0). 

My board is a stratix ii with ep2s60f1020c3 FPGA. 

 

Can you tell me why I can’t find the System Control Bus pins T20, T21, T25, T26 and V26 indicated in the stratix ii dsp development board reference manual when I use the pin planner of Quartus for ep2s60f1020c3 FPGA? 

 

Can you tell me what other pins assignments I could make for these pins? 

 

 

Thanks in advance. 

 

Cordially, 

Samson Bossé.
0 Kudos
1 Reply
Altera_Forum
Honored Contributor II
203 Views

Ethernet MAC/PHY (LAN91C111 device) is not an IP : is an IC. 

You have to assign signal to pins according to the documentation : page 2-25 of the reference manual. 

 

Cordially (Cordialement ne se dit pas, on dit Best Regards !) 

Bonne Journée !
0 Kudos
Reply