FPGA, SoC, And CPLD Boards And Kits
FPGA Evaluation and Development Kits
5892 Discussions

Ethernet interface not working on Max10 eval board with Linux

Altera_Forum
Honored Contributor II
1,022 Views

Hello, 

 

I have an Altera MAX10 10M50 Rev C Development Kit that want to setup under Linux. I have found the instructions below to set it up: https://rocketboards.org/foswiki/documentation/alteramax1010m50revcdevelopmentkitlinuxsetup 

 

It is working mostly: the board boots, and I can access the shell via the UART. The problem I have is I can't get the ethernet port to work. The PHY seems to be up (one LED lighted and the connection status is "up" as seen from the PC. 

I have tried forcing a static address with "ifconfig up" to no avail. I have attached the boot log for reference. 

 

Any help will be greatly appreciated. 

 

Best regards 

Loic
0 Kudos
1 Reply
Altera_Forum
Honored Contributor II
312 Views

Ok, my bad... 

eth0 is connected to port A, and I was plugged in port B.... 

Problem solved.
0 Kudos
Reply