FPGA, SoC, And CPLD Boards And Kits
FPGA Evaluation and Development Kits
6027 Discussions

FPGA Ball Damage - Request for RTV

Fahiza
Beginner
366 Views

I would like to request for this communication to be handled privately.

 

Hi Intel team,

Jabil detected 1 Pc of FPGA part with ball damaged at incoming.

Kindly advice next step for unit RTV.

 

Jabil P/N : c

MPN : EP2S90F1508C3

Affected qty : 1 Pc

Defect : Ball damaged

Vendor : Arrow Asia Distribution Ltd

 

Please refer attached for details and photo.

0 Kudos
1 Reply
Zawani_M_Intel
Employee
330 Views

Hi Fahiza,


For your information, Intel PSG perform 100% Ball Scan prior to shipment, so it's unlikely that the device will have been shipped with a missing ball. There is a high possibility that it was damaged in transit or shipping or improper storage. We have ball scan and visual test. Plus, we have drop test proved packing. The purpose of production testing during manufacturing is to screen out bad units and in the case, the missing solder ball would not pass the open/short test. Intel PSG Reliability Report had stated clearly that Intel PSG performs comprehensive testing and manufacturing controls on all its products. 


We could guarantee devices leave factory door in good condition. Once shipment leaves factory, we are no longer liable as it subjects to forwarder’s handling, distributor’s handling and customer’s handling. There is no way to tell if the damages are done before devices leave factory door. Therefore, no RMA/CN will be proceeded due to the missing ball issue reported.


Customer could investigate this to come out some corrective action. Meanwhile, you may refer to the solution below on the maximum downward pressure that can be applied to the top of BGA

https://www.intel.com/content/www/us/en/programmable/support/support-resources/knowledge-base/solutions/rd04172001_4367.html  


Thank you.


Regards,

Wani



0 Kudos
Reply