- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi, everyone. I'm trying to run a design directly from the Flash mem, but I don't know what Option bit address to use.
I've already written my program to flash through Parallel Flash Loader design using just the FPGA (EP2S60). But I can't find anywhere the Option bit address to use before converting my .sof to a .pof file. So MAX 7000 can't find my project after a board reset/restart. Does anyone know this address? I've already run through all Altera pdfs and couldn't find anything about this development board. Or is it necessary to rewrite the MAX 7000 program and then write the flash mem? Thank you a lot, MureLink Copied
0 Replies
Reply
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page