FPGA, SoC, And CPLD Boards And Kits
FPGA Evaluation and Development Kits
Announcements
Intel Support hours are Monday-Fridays, 8am-5pm PST, except Holidays. Thanks to our community members who provide support during our down time or before we get to your questions. We appreciate you!

Need Forum Guidance? Click here
Search our FPGA Knowledge Articles here.
5282 Discussions

Flashing a NIOS II DevKit with Stratix II EP2S60

Altera_Forum
Honored Contributor II
763 Views

Hello, 

I am pretty new to Altera FPGAs and Quartus II. To get started I have an older NIOS II development kit. I am able to use it for plain Quartus projects by making use of the Quartus II Programmer. However, I have not figured out how to write my design into the flash to make it permanent. Most posts I read about that, talk about making use of the on-board EPCSxx but it does not exists on my board. 

 

What I found in the documentation is a tool, to restore the orignal NIOS II configuration. This definitly will come in handy later. But for now, I want to replace this original configuration with my non-NIOS designs. 

 

Can anyone tell me how to do this? It might me so obvious, but I cannot see the solution.
0 Kudos
0 Replies
Reply