Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Altera_Forum
Honored Contributor I
729 Views

Graphic LCD display on Stratix III development board

Hi. 

Just recently acquired the dev kit, and the question might sound a bit silly, but im wrestling google and the altera site to find out to which header I should plug the LCD graphic display power connecter (and in which orientation). The manual and the reference documents that came with the kit dont say much about that, although it looks in the picture as if it should be connected to the j6 connector (which is a 2-pin header: GND and -12v), but I went on to see the LCD datasheet just to make sure and surprisingly found out that the maximum absolute voltage is 7v. 

Can anyone lend a hand here ? ;)
0 Kudos
1 Reply
Altera_Forum
Honored Contributor I
55 Views

Connector J6

Reply