FPGA, SoC, And CPLD Boards And Kits
FPGA Evaluation and Development Kits
6194 Discussions

HOW TO CONNECT BIDIR PAD on CYCLONE III FPGA

Altera_Forum
Honored Contributor II
1,059 Views

Hello, 

 

I have Cyclone III Starter kit Board and to connect a Bidirectional PAD ( data to SSRAM) I expect to connect 3 ports (1 input Data_in and 1 ouput Data_out, and 1 high impedance control), but on the chip planner, I cannot see such ports, how does quartus differentiate that ? Thanks a lot for your help  

 

regards Chahid
0 Kudos
1 Reply
Altera_Forum
Honored Contributor II
378 Views

As I understand you need an inout. This is a bidirectional port. How do you drive the ports NIOS or HDL?

0 Kudos
Reply