FPGA, SoC, And CPLD Boards And Kits
FPGA Evaluation and Development Kits
6128 Discussions

HOW TO CONNECT BIDIR PAD on CYCLONE III FPGA

Altera_Forum
Honored Contributor II
‎06-20-2014 04:02 PM
1,018 Views

Hello, 

 

I have Cyclone III Starter kit Board and to connect a Bidirectional PAD ( data to SSRAM) I expect to connect 3 ports (1 input Data_in and 1 ouput Data_out, and 1 high impedance control), but on the chip planner, I cannot see such ports, how does quartus differentiate that ? Thanks a lot for your help  

 

regards Chahid
0 Kudos

Link Copied

1 Reply
Altera_Forum
Honored Contributor II
‎06-20-2014 07:30 PM
337 Views

As I understand you need an inout. This is a bidirectional port. How do you drive the ports NIOS or HDL?

0 Kudos
Copy link
Reply

Community support is provided Monday to Friday. Other contact methods are available here.

Intel does not verify all solutions, including but not limited to any file transfers that may appear in this community. Accordingly, Intel disclaims all express and implied warranties, including without limitation, the implied warranties of merchantability, fitness for a particular purpose, and non-infringement, as well as any warranty arising from course of performance, course of dealing, or usage in trade.

For more complete information about compiler optimizations, see our Optimization Notice.