- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I have a simple question regarding the LVDS on the HSMC connectors. I'm using Stratix-III development kit.
Can the LVDS pins be defined as either input or output? Or are they "locked" into a particular direction? Please advise, thanks in advance,Link Copied
3 Replies
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Stratix families have dedicated LVDS RX and TX pins, so the assignament can't be changed.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Thank you for your reply.
OK, just for further clarification: so the Stratix-III pin AC11 connected to HSMC J18 pin 47 defined as HSMA_TX_P0, can ONLY be an LVDS output or redefined as a CMOS Input/Output 2.5V pin? Tschuess!- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
You have been asking for LVDS direction. All LVDS pins can be also used as single ended in- or ouput pin.
Reply
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page