- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I wanted to use the DC +5V (VCC5) pin on the expansion header to connect to my breadboard but I am not sure how to do it. The manual only states that the board has 8 pins that are either a source/gnd pin and their location on the board. In VHDL would I assign GPIO_0[11] GPIO_0[12] as output pins?
Link Copied
2 Replies
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
At least tell about the used Dev Kit and connector number.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Sorry about that. I have the DE2 board and the Cyclone II EP2C35F67C6N. I'm not sure what you mean by connection number.
Reply
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page