FPGA, SoC, And CPLD Boards And Kits
FPGA Evaluation and Development Kits
5925 Discussions

Help on how to use DC +5V (VCC5) and GND pins

Altera_Forum
Honored Contributor II
‎12-20-2010 01:46 AM
1,589 Views

I wanted to use the DC +5V (VCC5) pin on the expansion header to connect to my breadboard but I am not sure how to do it. The manual only states that the board has 8 pins that are either a source/gnd pin and their location on the board. In VHDL would I assign GPIO_0[11] GPIO_0[12] as output pins?

0 Kudos

Link Copied

2 Replies
Altera_Forum
Honored Contributor II
‎12-20-2010 08:33 AM
598 Views

At least tell about the used Dev Kit and connector number.

0 Kudos
Copy link
Altera_Forum
Honored Contributor II
‎12-20-2010 12:59 PM
598 Views

Sorry about that. I have the DE2 board and the Cyclone II EP2C35F67C6N. I'm not sure what you mean by connection number.

0 Kudos
Copy link
Reply

Community support is provided during standard business hours (Monday to Friday 7AM - 5PM PST). Other contact methods are available here.

Intel does not verify all solutions, including but not limited to any file transfers that may appear in this community. Accordingly, Intel disclaims all express and implied warranties, including without limitation, the implied warranties of merchantability, fitness for a particular purpose, and non-infringement, as well as any warranty arising from course of performance, course of dealing, or usage in trade.

For more complete information about compiler optimizations, see our Optimization Notice.