FPGA, SoC, And CPLD Boards And Kits
FPGA Evaluation and Development Kits
5892 Discussions

Hi, I am using Cyclone iv ep4ce6e22c8n fpga development kit from dueprologic. When i try to flash the code it is taking more than 10 minutes to complete the flashing. Can you please answer to this question? Regards Hareesh

HMoha11
Beginner
811 Views
 
0 Kudos
3 Replies
ShafiqY_Intel
Employee
419 Views

Hi HMoha11,

 

May I know which configuration file you are using (eg. .pof, .sof, .pof)?

 

Can you change your JTAG frequency to the 6MHz (default value)?

 

Thanks

 

0 Kudos
HMoha11
Beginner
419 Views

Hi MShafiq,

Thanks for your reply ,

I am using .pof configuration file. I think the board doesnt support other configuration like .sof

I will try reducing JTAG frequency.

May i ask you one question? Why do we need to reduce the clk freq.?

Regards,

Hareesh

 

 

0 Kudos
ShafiqY_Intel
Employee
419 Views

Hi Hareesh,

 

Sometime the signal integrity and timing prevents operating at 24 MHz. Thus, the optimum recommended value is 6 MHz (default value).

 

In addition, the TCK frequency cannot change using the USB-Blaster download cable.

https://www.intel.com/content/www/us/en/programmable/support/support-resources/knowledge-base/solutions/rd11142008_293.html

 

Thanks

0 Kudos
Reply