FPGA, SoC, And CPLD Boards And Kits
FPGA Evaluation and Development Kits
6185 Discussions

How can I change REFCLK_EMIF frequency on Cyclone 10 GX Development Kit?

MEmel1
Beginner
780 Views

Hello,

 

My problem is to change REFCLK_EMIF frequency coming from Si5332 to 50 or 100 MHz.

 

So far I can see only one option to re-program Si5332 via I2C from MAX10. But it too complicated and is going to take a while.

 

Is there any other quicker option?

0 Kudos
1 Solution
NurAida_A_Intel
Employee
549 Views

Dear MEmel1,

 

Thank you for joining this Intel Community.

 

You can use the clock controller GUI available in Cyclone 10 Dev Kit website to change the Si5332 frequency.

 

You may refer to this dev kit user guide on page 57 for more details:

https://www.intel.com/content/dam/www/programmable/us/en/pdfs/literature/ug/ug-c10-gx-fpga-devl-kit.pdf

 

Also attached is some guideline steps to configure the Si5332 clock generator. Hope this is helpful.

 

Thanks

 

Regards,

NAli1

 

View solution in original post

0 Kudos
2 Replies
NurAida_A_Intel
Employee
550 Views

Dear MEmel1,

 

Thank you for joining this Intel Community.

 

You can use the clock controller GUI available in Cyclone 10 Dev Kit website to change the Si5332 frequency.

 

You may refer to this dev kit user guide on page 57 for more details:

https://www.intel.com/content/dam/www/programmable/us/en/pdfs/literature/ug/ug-c10-gx-fpga-devl-kit.pdf

 

Also attached is some guideline steps to configure the Si5332 clock generator. Hope this is helpful.

 

Thanks

 

Regards,

NAli1

 

0 Kudos
MEmel1
Beginner
549 Views

Hello, NAli1.

This variant suits me perfectly!

 

Thank you very much for your help!

0 Kudos
Reply