- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
1 Solution
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
You can always right-click any message to get more info on the message, either from the built-in help or online, but the error is saying that you've set up GPIO from the HPS but haven't assigned them to I/O pins of the device in the Pin Planner.
#iwork4intel
Link Copied
2 Replies
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
You can always right-click any message to get more info on the message, either from the built-in help or online, but the error is saying that you've set up GPIO from the HPS but haven't assigned them to I/O pins of the device in the Pin Planner.
#iwork4intel
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
Yeap, you can right-click any of the message to get more information on the error message that you're getting.
Do you have any additional question?
Reply
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page