FPGA, SoC, And CPLD Boards And Kits
FPGA Evaluation and Development Kits
5929 Discussions

How to adjust the supply voltage of Cyclone III on DE0 board

Altera_Forum
Honored Contributor II
‎04-15-2014 09:51 PM
966 Views

Hi all, 

I am doing an experiment on DE0 board, which requires the adjustment of supply voltage (VDD) of Cyclone III. I have read the manual of DE0 board carefully and did not find any clue to do it. It seems that the USB cable (for programming) can provide the power for DE0 board directly. Thanks very much for any help on it.
0 Kudos

Link Copied

1 Reply
Altera_Forum
Honored Contributor II
‎06-06-2014 08:58 AM
233 Views

Hi there, 

 

Could you be more specific on the VDD that you are trying to adjust ? There are VCCINT, VCCIO, VCCD, and VCCA supplied/connected to the Cyclone III device.  

 

I'm not sure if the USB cable solely can supply enough power to run anything on the DE0 board. 

 

David from Terasic
0 Kudos
Copy link
Reply

Community support is provided during standard business hours (Monday to Friday 7AM - 5PM PST). Other contact methods are available here.

Intel does not verify all solutions, including but not limited to any file transfers that may appear in this community. Accordingly, Intel disclaims all express and implied warranties, including without limitation, the implied warranties of merchantability, fitness for a particular purpose, and non-infringement, as well as any warranty arising from course of performance, course of dealing, or usage in trade.

For more complete information about compiler optimizations, see our Optimization Notice.