FPGA, SoC, And CPLD Boards And Kits
FPGA Evaluation and Development Kits
5341 Discussions

How to expand Cyclone III FPGA Starter Board for USB interface

Altera_Forum
Honored Contributor II
822 Views

I am using Cyclone III FPGA Starter Board. I want to communicate PC with sevral byte data. Now I am using Bitec HSMC prototype daughter card and control some device. I looked forum, someone suggest that we should use additional board as usb 2.0 ulpi/otg (isp1504 phy). but there are no SantaCruz interface in Cyclone III FPGA Starter Board. I want to know how to configure SantaCruz interface on HSMC prototype daughter card. 

Thank you. 

0 Kudos
1 Reply
Altera_Forum
Honored Contributor II
142 Views

terasic (http://www.terasic.com.tw/cgi-bin/page/archive.pl?language=english&categoryno=65#category67) have a few HSMC boards, one of them having a USB connector. You can also find a HSMC to SantaCruz converter if you prefer.

Reply