- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I am using Cyclone III FPGA Starter Board. I want to communicate PC with sevral byte data. Now I am using Bitec HSMC prototype daughter card and control some device. I looked forum, someone suggest that we should use additional board as usb 2.0 ulpi/otg (isp1504 phy). but there are no SantaCruz interface in Cyclone III FPGA Starter Board. I want to know how to configure SantaCruz interface on HSMC prototype daughter card.
Thank you.Link Copied
1 Reply
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
terasic (http://www.terasic.com.tw/cgi-bin/page/archive.pl?language=english&categoryno=65#category67) have a few HSMC boards, one of them having a USB connector. You can also find a HSMC to SantaCruz converter if you prefer.
Reply
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page