FPGA, SoC, And CPLD Boards And Kits
FPGA Evaluation and Development Kits
Announcements
Intel Support hours are Monday-Fridays, 8am-5pm PST, except Holidays. Thanks to our community members who provide support during our down time or before we get to your questions. We appreciate you!

Need Forum Guidance? Click here
Search our FPGA Knowledge Articles here.
5282 Discussions

How to expand Cyclone III FPGA Starter Board for USB interface

Altera_Forum
Honored Contributor II
814 Views

I am using Cyclone III FPGA Starter Board. I want to communicate PC with sevral byte data. Now I am using Bitec HSMC prototype daughter card and control some device. I looked forum, someone suggest that we should use additional board as usb 2.0 ulpi/otg (isp1504 phy). but there are no SantaCruz interface in Cyclone III FPGA Starter Board. I want to know how to configure SantaCruz interface on HSMC prototype daughter card. 

Thank you. 

0 Kudos
1 Reply
Altera_Forum
Honored Contributor II
134 Views

terasic (http://www.terasic.com.tw/cgi-bin/page/archive.pl?language=english&categoryno=65#category67) have a few HSMC boards, one of them having a USB connector. You can also find a HSMC to SantaCruz converter if you prefer.

Reply