- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
How to use HPS internal oscillator as a source for both main and peripheral PLL.
I tried by choosing the Internal oscillator in a general configuration in Platform Designer device->device and pin options. But it does not work. How I verified this by reading the main_pllglob register. The address is 0xFFD10048. The VCO source is kept at 0 even though I chose it as an internal oscillator.
Thanks,
Regards,
Veerappan P.
Link Copied
1 Reply
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi Veerappan,
Apologies for the long delay in replying , was on medical leave for 2 weeks and my forum account access got revoked, just manage to regain access this week.
I will look into this case and feedback to you later, once again I'm sorry for the long response delay.
Thanks
Regards
Kian

Reply
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page