- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I know there are concerns like I/o pins, memory, cost, etc, but in order to make sure that the FPGA meets my requirements from the IR sensor, what strategy/procedure should I adapt?
Link Copied
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
As I understand it, you have some inquiries related to FPGA part selection for your target application. Just would like to check with you if you are aware of your local sales or FAEs? It is recommended for you to get in touch with them so that they could further assist you in part selection.
Alternatively, you may also try out the web version of product selector guide to see if it is helpful in your part selection:
https://www.intel.com/content/www/us/en/programmable/products/product-selector-guide.html
Please let me know if there is any concern. Thank you.
Best regards,
Chee Pin
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
When you enter the selector guide, next page ends on an error
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
Sorry for the inconvenience. I believe this is due to some issue with the web server. As a workaround, I would recommend you to connect with the local sales or FAE to further assist you on the part selection. Sorry for the inconvenience.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
For your information, you may also visit the following webpage to look for the sales contact closest to your region. Please let me know if there is any concern. Thank you.
https://www.intel.com/content/www/us/en/partner/where-to-buy/overview.html
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page