FPGA, SoC, And CPLD Boards And Kits
FPGA Evaluation and Development Kits
6128 Discussions

I would like to know if is possible to program the Si5351 clock generator on the Cyclone 10LP Evaluation Kit without using GUI

MCHOW8
Beginner
‎04-02-2019 12:18 AM
1,065 Views

I would like to be able to program the Max10 on board to configure the clock generator - is it possible to connect to and reconfigure the Max10? Also I've had

trouble finding the maximum acceptable clock rate for the Cyclone 10 LP in the specs...

0 Kudos

Link Copied

3 Replies
AR_A_Intel
Employee
‎04-04-2019 08:13 AM
612 Views
Hello Welcome to INTEL forum. We don’t have alternative way to program it. Please use GUI as it is available in the installation kit.
0 Kudos
Copy link
MCHOW8
Beginner
‎04-04-2019 05:49 PM
612 Views
In response to AR_A_Intel

Hi AAbd,

 

Thanks for the response. I would like to be able to power cycle the board and maintain the set frequency. Is there a way to do that with the GUI?

In response to AR_A_Intel
0 Kudos
Copy link
AR_A_Intel
Employee
‎05-03-2019 02:07 AM
612 Views

Base on my understanding, NO, there are no option with GUI to able you to on the board and maintain the set frequency on the same time.

0 Kudos
Copy link
Reply

Community support is provided Monday to Friday. Other contact methods are available here.

Intel does not verify all solutions, including but not limited to any file transfers that may appear in this community. Accordingly, Intel disclaims all express and implied warranties, including without limitation, the implied warranties of merchantability, fitness for a particular purpose, and non-infringement, as well as any warranty arising from course of performance, course of dealing, or usage in trade.

For more complete information about compiler optimizations, see our Optimization Notice.