- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
There are 37 nodes in my design that are identified in Section 5 of the power analysis as having indeterminate toggle rates. 35 of them are internal to the auto generated (inferred) multiplier. Is there any way for me to provide toggle rates for these nodes to eliminate the warning? Device is 10M08, tool is Quartus Prime Lite Edition 18.1.0 Build 625 09.12.2018.
Link Copied
2 Replies
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Yes ,
Have you tried to give toggle rate from Quartus
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi ,
Kindly let me know, if you need further assistance.

Reply
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page