FPGA, SoC, And CPLD Boards And Kits
FPGA Evaluation and Development Kits
5892 Discussions

Is it possible to skip reconfiguration of transceiver when use displayport on Cyclone V SoC

Mingyuexin
Beginner
486 Views

Hi,

I'm trying to design a video interface by using displayport on Cyclone V SoC device, I referred to the example design located (C:\intelFPGA\18.1\ip\altera\altera_dp\hw_demo\cv). In this example, a module is used to reconfig the transceiver, in my design, I do not plan to config the link rate during the run, is it possible to skip reconfig module?

 

Thank you very much in advance

Jasmine

0 Kudos
1 Solution
Deshi_Intel
Moderator
327 Views
Hi, transceiver reconfig interface is already hard coded as part of the feature in Intel FPGA Display Port IP. It's not something that can be disable. I am sorry but you can't skip it. Thanks. Regards, dlim

View solution in original post

0 Kudos
3 Replies
Deshi_Intel
Moderator
328 Views
Hi, transceiver reconfig interface is already hard coded as part of the feature in Intel FPGA Display Port IP. It's not something that can be disable. I am sorry but you can't skip it. Thanks. Regards, dlim
0 Kudos
Mingyuexin
Beginner
327 Views

Thank you very much for the answer.

0 Kudos
Deshi_Intel
Moderator
327 Views
You are welcome !
0 Kudos
Reply