FPGA, SoC, And CPLD Boards And Kits
FPGA Evaluation and Development Kits
Announcements
Intel Support hours are Monday-Fridays, 8am-5pm PST, except Holidays. Thanks to our community members who provide support during our down time or before we get to your questions. We appreciate you!

Need Forum Guidance? Click here
Search our FPGA Knowledge Articles here.
4965 Discussions

It is good to load SOF online in JTAG mode. But when I load JIC, but cannot load,why?

FWang44
Beginner
227 Views

Hello everyone,

I am using EP4CGX75F23I7 FLASH EPCS64.It is good to load SOF online in JTAG mode. But when I load JIC, but cannot load.

the following is our related schematic and configuration,

 

1578629100(1).jpg1578629118(1).jpg1578629272(1).jpg1578629085(1).jpg

thank you

0 Kudos
1 Reply
ak6dn
Valued Contributor II
103 Views

Do you have the altserial_flash_loader module instantiated in your top level source file?

 

If you do, and after you load the SOF file, you should see TWO JTAG devices on your chain, the FPGA, and the EEPROM.

If you only still see the FPGA you probably don't have the EEPROM interface module present/configured, or your EEPROM circuit wiring is incorrect.

Reply