FPGA, SoC, And CPLD Boards And Kits
FPGA Evaluation and Development Kits
Announcements
Intel Support hours are Monday-Fridays, 8am-5pm PST, except Holidays. Thanks to our community members who provide support during our down time or before we get to your questions. We appreciate you!

Need Forum Guidance? Click here
Search our FPGA Knowledge Articles here.
4973 Discussions

MAX 10 Development Kit RGB Led

Altera_Forum
Honored Contributor I
804 Views

Hi, 

I am new to altera FPGAs and purchased recently the 

MAX 10 FPGA Development Kit, embedded with 10M50DAF484C6GES fpga. 

 

I am using the dev-board rev C, and looking at the schematics of the dev-board 

I see the RGB led is connected to the FPGA at pins r->E2, g->E3, b->E4. 

However, I am trying to drive the rgb led on/off and it doesn't work (no voltage change on nmos gates). 

In addition at pin planner screen, pin E2 is connected to ground internally inside the FPGA, which means i can't assign any signal to this pin. 

 

Is the RGB led available to use with my dev-board? 

 

 

EDIT: 

I didn't notice the RGB led is not connected to the FPGA on board but to the embedded on board blaster. 

 

 

Thanks
0 Kudos
0 Replies
Reply