Community
Register Help
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
Altera_Forum
Honored Contributor I
‎06-22-2015 03:08 PM
954 Views

MAX II Development Board Kit - Incorrect pinout

Hi! 

 

I noticed the pinout provided for the expansion header pins in Figure 3 from document max ii development board reference manual (Document version 6.0.1 October 2006) shows that Pin 2 from connector J3 is NC (not-connected), whereas it's actually connected to +5V in the board (as shown in the schematics provided within the same complete kit documentation - ftp://ftp.altera.com/outgoing/devkit/mii_1270n_kit-v6.0.1.exe). 

 

I tried to find new versions of the reference manual, without success. 

 

Any comments? 

 

Gabriel
0 Kudos
Reply

Link Copied

1 Reply
Altera_Forum
Honored Contributor I
‎06-23-2015 12:36 AM
33 Views

This might be a bug in the documentation or schematic. I think you can file a service request to Altera to seek for clarification.

0 Kudos
Copy link
Reply
Reply

For more complete information about compiler optimizations, see our Optimization Notice.