FPGA, SoC, And CPLD Boards And Kits
FPGA Evaluation and Development Kits
The Intel sign-in experience is changing in February to support enhanced security controls. If you sign in, click here for more information.
5421 Discussions

Max 10 Dev Kit does not show up in Programmer after writing .pof to CFM

Honored Contributor II



I have the Max 10 (10M50DAF484C6GES) dev kit and I wrote my .pof design to the CFM using Programmer successfully. Once it was programmed, I powered OFF then powered ON the Max 10. With the Max 10 still connected, I scanned the chain with Programmer but the device does not show up. When I hit "Auto Detect" I receive a message "Unable to scan device chain. Hardware is not connected." Is this because I wrote over the CFM? Is there a way to reprogram the CFM back to the factory default?  


Thank You
0 Kudos
0 Replies