Max V board test system hangs when using Config

[Altera_Forum]

Just received a Max V cpld Development kit. 

 The Board test System GUI runs ok and I can turn off/on Leds etc. However when using Config to alter the configuration it hangs with 'Configure with pof/bts_por.pof' for example shown in the lower text box. Quiting the board test gui and then restarting returns to the original config. I've tried running Quartus II (Service Pack 1 installed) at the same time, but to no avail. Please help anyone! Thanks.

[Altera_Forum]

--- Quote Start ---  Just received a Max V cpld Development kit.  The Board test System GUI runs ok and I can turn off/on Leds etc. However when using Config to alter the configuration it hangs with 'Configure with pof/bts_por.pof' for example shown in the lower text box. Quiting the board test gui and then restarting returns to the original config. I've tried running Quartus II (Service Pack 1 installed) at the same time, but to no avail. Please help anyone! Thanks.  --- Quote End ---    Did you get this resolved? I am having that exact problem today. Any suggestions?

[Altera_Forum]

--- Quote Start ---  Did you get this resolved? I am having that exact problem today. Any suggestions?  --- Quote End ---    Hi. I'm afraid I failed to resolve this. In spite of having purchased their development board, Altera refused to provide any technical help. My only option was this forum. Unfortunately yours was the only response.  Hope you have more success than I did.

[Altera_Forum]

--- Quote Start ---  Hi. I'm afraid I failed to resolve this. In spite of having purchased their development board, Altera refused to provide any technical help. My only option was this forum. Unfortunately yours was the only response.  Hope you have more success than I did.  --- Quote End ---    I found a Youtube video that shows how to use the demos.  https://youtu.be/g7h1ggny3zs  Good luck!