FPGA, SoC, And CPLD Boards And Kits
FPGA Evaluation and Development Kits
Announcements
The Intel sign-in experience has changed to support enhanced security controls. If you sign in, click here for more information.
5540 Discussions

Max V board test system hangs when using Config

Altera_Forum
Honored Contributor II
1,087 Views

Just received a Max V cpld Development kit. 

 

The Board test System GUI runs ok and I can turn off/on Leds etc. 

However when using Config to alter the configuration it hangs with 'Configure with pof/bts_por.pof' for example shown in the lower text box. 

Quiting the board test gui and then restarting returns to the original config. 

I've tried running Quartus II (Service Pack 1 installed) at the same time, but to no avail. Please help anyone! 

Thanks.
0 Kudos
3 Replies
Altera_Forum
Honored Contributor II
150 Views

 

--- Quote Start ---  

Just received a Max V cpld Development kit. 

 

The Board test System GUI runs ok and I can turn off/on Leds etc. 

However when using Config to alter the configuration it hangs with 'Configure with pof/bts_por.pof' for example shown in the lower text box. 

Quiting the board test gui and then restarting returns to the original config. 

I've tried running Quartus II (Service Pack 1 installed) at the same time, but to no avail. Please help anyone! 

Thanks. 

--- Quote End ---  

 

 

Did you get this resolved? I am having that exact problem today. Any suggestions?
Altera_Forum
Honored Contributor II
150 Views

 

--- Quote Start ---  

Did you get this resolved? I am having that exact problem today. Any suggestions? 

--- Quote End ---  

 

 

Hi. I'm afraid I failed to resolve this. In spite of having purchased their development board, Altera refused to provide any technical help. My only option was this forum. Unfortunately yours was the only response. 

 

Hope you have more success than I did.
Altera_Forum
Honored Contributor II
150 Views

 

--- Quote Start ---  

Hi. I'm afraid I failed to resolve this. In spite of having purchased their development board, Altera refused to provide any technical help. My only option was this forum. Unfortunately yours was the only response. 

 

Hope you have more success than I did. 

--- Quote End ---  

 

 

I found a Youtube video that shows how to use the demos. 

 

https://youtu.be/g7h1ggny3zs 

 

Good luck!
Reply