- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello,
I'm a freshman working on the Nios II Development Kit, Stratix II Edition. I want to use this Development Kit to control a vedio decoder.This vedio decoder is designed to work with 3.3V signals, and are not tolerant of 5V signals. I know the proto1 & proto2 connectors on the development kit can output 5V signals. The Reference manual http://www.altera.com.cn/literature/manual/mnl_nios2_board_stratixii_2s60_rohs.pdf said , "The output logic-level on the expansion prototype connector pins is 3.3 V." -page27. I don't know how to use the proto1 & proto2 connectors to output 3.3V signals. Can you tell me the answer? Or is there any other connectors on the board can output 3.3V signal which is controlled by the FPGA? Many thanks! Sincerely TannyaLink Copied
0 Replies
Reply
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page