Nios II does not run after power up in my DE0-NANO

FPGA, SoC, And CPLD Boards And Kits

FPGA Evaluation and Development Kits

Nios II does not run after power up in my DE0-NANO

852 Views

Hi,

I have a DEO-NANO board and I am new in FPGA world , I have followed the DEO-NANO manual and everithyng is ok but when I try to leave in my EPCS mi nios program+ my firmware I am not able to make it work (only the nios program) after unplug the system and power it up again, I have seen a lot of info but I am not able to get my nios program work after power it up.

Please help my. With my VHDL files I have not problem in putting them in my EPCS as a JIC file, and they work perfecty after power up, but with the nios program I has not be able. I use the nios system of the DEO_NANO CD that include the EPCS, and I have only changed the nios type to the e version. It seems as if the nios program is not started once I power up the system but I dont know why.

masacate

Thanks

Link Copied

0 Replies

Community support is provided during standard business hours (Monday to Friday 7AM - 5PM PST). Other contact methods are available here.

Intel does not verify all solutions, including but not limited to any file transfers that may appear in this community. Accordingly, Intel disclaims all express and implied warranties, including without limitation, the implied warranties of merchantability, fitness for a particular purpose, and non-infringement, as well as any warranty arising from course of performance, course of dealing, or usage in trade.

For more complete information about compiler optimizations, see our Optimization Notice.