FPGA, SoC, And CPLD Boards And Kits
FPGA Evaluation and Development Kits
Announcements
Intel Support hours are Monday-Fridays, 8am-5pm PST, except Holidays. Thanks to our community members who provide support during our down time or before we get to your questions. We appreciate you!

Need Forum Guidance? Click here
Search our FPGA Knowledge Articles here.
4953 Discussions

No CFI table found at address on Stratix IV GX development kit

Altera_Forum
Honored Contributor I
920 Views

Development kit: Stratix IV GX FPGA Development Kit (RoHS), 530 Edition f 

FPGA: EP4SGX530KH40C4 

Quartus version: 11.1 SP2 

OS: Debian 

 

I accidentally rewrote flash memory of Stratix 4 GX development kit and trying to restore it to default board update portal, according to User Guide. 

 

I changed all dip switches to factory one. 

I uploaded SOF image s4gx530_fpga_bup.sof, using both programmer GUI from quartus and programmer CLI (using command nios2-configure-sof). 

When I'm trying to reprogram flash memory with command (bash ./restore.sh) and writing "r", I'm receiving following error: 

 

nios2-flash-programmer -b 0x08000000 restore_s4gx530_fpga_bup.flash 

 

Using cable "USB-Blaster [1-2]", device 1, instance 0x00 

Resetting and pausing target processor: OK 

No CFI table found at address 0x08000000 

Leaving target processor paused 

 

Note: the board FPGA should be configured as described  

in the User's Guide, chapter entitled:  

"Restoring the Flash Device with the Factory Settings" 

 

Done. 

 

I tried using different version of quartus 2 (11.1 sp2, 11.1), quartus prime (15.1, 16.1) and programmer, but nothing really changes this error. 

 

Can you help me out with pointing what should I be looking for?
0 Kudos
2 Replies
Altera_Forum
Honored Contributor I
82 Views

Hello Pogasanov, 

Did you solve the issue?
Altera_Forum
Honored Contributor I
82 Views

Hello , I have a same problem with you.But the board is different: it is a cyclone v gx board . Do you solve the problem now ?

Reply