- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi!
I have been going through the Stratix2 DSP development Board Reference manual and Datasheet documents and I cannot understand fully how to configure the board with a user-defined non-volatile configuration. I have sucessfully generated the intel hex output in Quartus, but from then on I don't know what to do. Could anybody plese give me a step-by-step explanation of what needs to be done to complete this operation? Thanks very much!Link Copied
0 Replies
Reply
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page