OneAPI and FPGA boards support

[Luigi-Crisci]

Hi,

I'm kinda new in the FPGA world and I'm a bit confused about oneAPI support to FPGA.

I want to buy an FPGA with an embedded processor, probably an Arria 10 SX, and program it using SYCL. However, I checked some online references on the Intel site but they only reference the Programmable Acceleration Card (PAC) versions. 

Is it possible to program with oneAPI the FPGAs mounted on a board?

[aikeu]

Hi Luigi-Crisci,

You can try to use devcloud for oneAPI first to know better. There are a few types of boards which are supported in Devcloud.

Refer to the link below to try out:

https://github.com/intel/FPGA-Devcloud/tree/master/main/Devcloud_Access_Instructions#devcloud-access-instructions

Thanks.

Regards,

Aik Eu

[aikeu]

Hi Luigi-Crisci,

I will close this thread if no further question.

Thanks.

Regards,

Aik Eu